What's the matter with the nail polish glue?

If the nail surface is not clean enough and the grease film on the surface is not wiped clean, it may cause the subsequent glue to not stick. In addition, if the sponge is not polished properly or the lighting time is too long, the nail polish will dry and crack due to excessive drying. Therefore, when taking the glue, use the bottle mouth to gently scrape off the nail polish on the brush rod, and then scrape off the nail polish on the back of the brush head, leaving only a small amount of nail polish on the front; the brush head and the nail surface are at 45° , paint from one direction of the nail surface to the other side; note that the technique must be light, and apply forward along the trailing edge. In this way, there will be no uneven coating of the nail polish.

If the nail polish is applied too thickly, the outer layer is dry when the light is on, and the bottom layer is not completely dry, or if you like to take your hand out for observation when the light is on, it is prone to wrinkling. When applying nail polish, you must follow the guidelines of a small amount and many times. If you are worried that the color is not solid enough, you can apply a few more layers; the lighting time must be sufficient, and you must resist the curiosity to observe, so that there will be no wrinkling. 

How to brush nail polish glue evenly?

1. Nail polish should not be too viscous or too thin, too thick will lead to too thick coating, too thin will lead to uneven nail coating, so scrape off the nail polish on the back of the brush rod and brush head, and then apply.

2. How to apply: Turn the customer's palm over first, lift the applied fingers, take a small amount of base oil for edging, and apply from the little finger to the thumb. After wrapping the edge, turn the palm over to apply the base oil. The order of application is from the middle to the two sides (one stroke in the middle, one stroke on the left, one stroke on the right) until it is completely dry before applying the bright oil. The application method Apply with base oil.

3. After the base oil is completely dry, apply nutrient solution to the dead skin around the finger edge to prevent the occurrence of barbs.

New 48colors solid color cream gel paint gel, SK-CJ16